An off-note in a body cream, or a faint discoloration at the crimp of a tube, occasionally traces back to the printed packaging rather than the formula. Ink and adhesive components can migrate through a laminate into the product, and the amounts involved are measured in parts per billion, well below any sensory threshold until they are not.
1. The Complaint as It Arrives
Usually as a taste or smell in a lip product, or a brownish ring where product sat against the tube shoulder. Nobody suspects the tube, so the formula is reformulated twice before a gas chromatography screen finds a photoinitiator or a solvent residue. The test costs less than the second sample round.
2. Set-Off and Migration Are Different
Set-off happens during rewinding, when wet ink from the printed face transfers to the reverse. It is visible, and it is a print defect. Migration happens through the substrate over weeks, driven by concentration gradient and temperature. It is invisible until it reaches the product, and it does not stop at the print room.
3. Which Components Move
Low molecular weight photoinitiators from UV-cured inks, residual solvents from solvent-based systems, mineral oil from some offset inks, and plasticisers or tackifiers from adhesives. Small, lipophilic molecules move fastest, which is why fatty formulas in direct contact are the highest-risk combination.
4. The Barrier Layer
An aluminium foil layer of 9-12 micrometres is close to absolute for these migrants. EVOH and metallised films reduce but do not stop transmission, and their performance depends on humidity. A tube with an aluminium barrier and a food-grade inner sealant is the standard answer for a high-fat product with a long shelf life.
5. Testing Migration
Packaging migration is measured with a migration cell: printed material on one side, a simulant or the actual product on the other, held at 40 C for ten days. The receiving phase is then screened by gas chromatography with mass detection. Detection limits of a few parts per billion are routine, so a non-detect result is meaningful.
6. Where the Risk Concentrates
Lip products, body butters and anything applied to a large skin area with a high oil load. A face cream in a glass jar with a printed label on the outside carries almost no risk. A 200 ml laminated tube of body butter printed five colours carries a great deal, because the ink sits millimetres from the product.
7. Adhesives and Solvent Retention
Lamination adhesive is the other source. Solvent retention above roughly 5 mg per square metre signals an incomplete dry, and the residue will move. Ask for the laminator’s retention figure and the adhesive declaration; both are standard documents, not special requests.
8. What to Put in the Purchase Order
Name the ink system as low-migration, require an aluminium barrier layer where the product is fatty, ask for a migration declaration and a set-off check, and specify the solvent retention limit. Add one line about the inner sealant being suitable for direct food-contact equivalence. Suppliers quote to what is written, not to what is implied.
9. Cost and Lead Time
A low-migration ink system and a foil barrier typically add 10-20% to tube cost and two to three weeks to the first run, mostly for print approval and the declaration. Against a recall or a reformulation round, that is cheap. For repeat orders the premium stays but the lead time returns to normal.
10. Where it fits
Migration is decided at the print specification stage. Compare pack options in products, read related quality notes in news, and check the laminate background in the encyclopedia. For oil-rich lines such as body butter, specify a foil barrier in the brief.