Silicone-free requests arrive from brands targeting clean-beauty shelves, from markets with specific labelling expectations, and sometimes from a single retailer’s ingredient policy. Removing dimethicone is technically simple and commercially awkward: the feel changes, and the sample rounds multiply.
1. Why the Brief Arrives
The request is usually driven by positioning rather than by a documented safety concern. Retailer ingredient lists, certification schemes and social media pressure all push in the same direction. It is worth asking which market and which retailer, because a silicone-free claim that satisfies one channel may be unnecessary work for another. A brief that names the channel usually saves a whole sample round.
2. What Dimethicone Actually Does
At 2-5% in an emulsion it improves spreadability, reduces tack, adds a dry slip and forms a light breathable film that slows water loss. It also reduces whitening when the cream is rubbed in. Remove it and the formula usually feels heavier, tackier and slower to absorb, even when the oil phase is unchanged.
3. The Usual Replacements
Isoamyl laurate, C12-15 alkyl benzoate, caprylic/capric triglyceride and squalane carry much of the sensory load. Silicone copolyol functions are harder: wetting and spreading can be approximated with a low-HLB emulsifier plus an ester, but not matched. Each swap changes viscosity, so the thickener usually needs adjusting as well.
4. Texture Changes You Will See
Expect a slower rub-in and more residual shine at the same oil load. Whitening on rub-in often increases, which matters for body products used on deeper skin tones. The cream may also feel warmer on application because the volatile carrier that gave a cooling effect is gone. Panel-test against the original, blind.
5. Stability and Compatibility Effects
Silicones are chemically inert, so removing them makes the formula more reactive, not less. Esters hydrolyse, oils oxidise, and the emulsifier system now has to stabilise a different oil phase. Plan an accelerated stability run and a compatibility test with the pack, because both can surprise you on a silicone-free version.
6. What It Does to Cost
Cosmetic-grade dimethicone is inexpensive. The esters that replace it usually cost more per kilo and are used at a higher percentage. A realistic increase is 3-8% on bulk cost for a cream, and more for a serum where sensory weight is concentrated. Quote the change before the sample work, not after.
7. Where the Claim Is Hard
Colour cosmetics are the difficult category. Silicones carry pigment, control pay-off and stop a powder from dragging. A silicone-free foundation or primer is possible but needs a different binder, a new wear test and often a new pan or pump specification, because the texture that spreads easily in a silicone base becomes stiff and patchy without it. Skincare emulsions, body lotions and masks are the straightforward cases.
8. Label and Claim Wording
Silicone-free is a composition claim, so it needs a definition. Specify which INCI families you exclude, including cyclosiloxanes and silane-treated pigments, because treated pigments are where most claims quietly break. Put that definition in the specification so the artwork and the formula cannot drift apart.
9. Sample Rounds to Budget
Two rounds minimum, three if the product is a serum or a foundation. Round one fixes texture, round two checks stability and pack compatibility, round three confirms the panel result. Each round is typically three to four weeks, so a silicone-free switch adds six to ten weeks to a launch timeline.
10. Where it fits
Reformulation decisions belong with the product brief. Compare formats in products, read adjacent development notes in news, and see the ingredient background in the encyclopedia. For emulsion lines such as body butter, scope the claim before the sample round starts.